Mettler Toledo M300 FLOW Especificaciones descargar pdf (Pagina 36)

Transmitter O

M300 36

M300

Printed in Switzerland 52 121 305

8.6.2 Clean

Conﬁgure the Relay to be used for the cleaning cycle.

The Cleaning Interval can be set from 0.000 to 999.9 hours. Setting it to 0 turns the clean

cycle is off. The cleaning time can be 0 to 9999 seconds and must be smaller than the

Cleaning Interval.

Select the desired Relay state: Normal or Inverted.

Pressing the [ENTER] key again will bring up the Save Changes dialog. Selecting „No" will

discard the entered values, selecting „Yes" will make the entered values the current ones.

8.7 Display

(PATH: Menu/Conﬁgure/Display)

This Menu allows for the conﬁguration of the values to be displayed and also the conﬁguration

of the Display itself.

8.7.1 Measurement

The Display has in 4 Lines. Line 1 on top and Line 4 on the bottom.

Select the values (channels) to be displayed on each line of the display.

If this is set to On then when an alarm occurs the message "Failure – Press [ENTER] will be

on Line 4 in the normal measurement mode.

Pressing the [ENTER] key again will bring up the Save Changes dialog. Selecting „No" will

discard the entered values, selecting „Yes" will make the entered values the current ones.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 63 64

Sin comentarios

Mettler Toledo M300 FLOW Especificaciones Pagina 36